Page 1 of 1

Prototype Shield

PostPosted: Wed Jun 04, 2014 4:23 pm
by geoff138
To stop other others scratching their heads! can you add some relevant information to the board info.

This is :-

Both the GND strips by the SM pads are connected to the connector that plugs in to J5 pins 6&7 on the R2 board.
The GND strip at the end of the board connects only to J6 pin 7


Their is NO connection between these GND's until the board is plugged into the Firewing which can cause confusion when continuity checking !

Regards

Geoff

Re: Prototype Shield

PostPosted: Wed Jun 04, 2014 4:45 pm
by David John Barker