Hi,
I have an old Firewing board, I think it is a R1 version. I am using PDS to program it and I think it has worked in the past but now I do not think it is.
I am trying a very simple LED flash program found here http://www.protonbasic.co.uk/showthread ... t-hardware post 8.
The board shows up in device manager as a COM port and says it is working correctly.
When I download it seems to go very quickly, all I see is "Programming" and then another message flashes up too quick to see, the TX/RX LED's flash quickly.
The program does not appear to work or it has worked and messed up bootloader, The TX LED flashing at about the same rate as what I would expect from the program but changing the value does nothing.
If I look with a serial monitor I get 2b2z:2 repeatedly, is this normal?
Regards,
Bob