If you set the tab space count number to 4. Tabbing a single line moves 4 places
If you select a block and use Ctrl+Tab the block only moves 3
Would be nice if they matched.
Just a comment on Tabbing in the IDE
1 post
• Page 1 of 1
Just a comment on Tabbing in the IDE
by Timbo » Mon Jun 15, 2015 7:41 am
Just a FYI if the editor gets any changes
If you set the tab space count number to 4. Tabbing a single line moves 4 places
If you select a block and use Ctrl+Tab the block only moves 3
Would be nice if they matched.
If you set the tab space count number to 4. Tabbing a single line moves 4 places
If you select a block and use Ctrl+Tab the block only moves 3
Would be nice if they matched.
- Timbo
- Posts: 93
- Joined: Fri May 03, 2013 7:51 pm
1 post
• Page 1 of 1
Return to Development Environment
Who is online
Users browsing this forum: No registered users and 1 guest