Hardware I2C

[Coccoliso]

Hi,
I have a problem with the module HI2C.BAS and PIC24 R2 or at least I not understand how to use it.
The module should use as SCL the pin RB8 / SCL1 and as SDA the pin RB9 / SDA1 right?
I have to make additional settings?
On the module there is no reference to the two signals options (I2C_SCL / I2C_SDA).
Have to set the two pins in any particular way?

[Jerry Messina]

Right. RB8 and RB9 are the hardware I2C pins. SDA will be on J8-4 (D3) and SCL will be on J8-3 (D2).

You shouldn't have to set anything else. They become active when the module is enabled.